Table of Contents
Advertisement
12. Reverb
This knob adjusts the amount of reverb that is applied to the
vocals when the effects are enabled. If the Reverb button is
pressed to send the guitar signal to the reverb then this knob
also controls the amount of reverb on the guitar.
The three buttons select the character of the reverb: Studio
selects a standard studio plate reverb, Room selects a medium-
sized room and Hall selects a large concert hall.
13. Part A/B Footswitch
Pressing this footswitch quickly will toggle between the A and B
Parts of the Harmony Patch. Pressing and holding this footswitch
will slowly step between the Vocalist Live 3's Harmony Patches.
Release the footswitch when the desired Patch is reached.
The two LEDs above the footswitch Indicate whether Part A or
Part B of the Harmony Patch is selected. The green LED on the
left indicates Part A, the red LED on the right indicates Part B.
14. Effects Footswitch
Pressing the Effects footswitch quickly will enable and disable the
Pitch Correction, Chorus, Reverb and Delay Effects. It does not
affect the Pre-Effects (Warmth, Compressor, EQ, Low Cut, and
Noise Gate) which are always active. Pressing and holding the
switch will engage the Tuner. The Effects LED flashes when the
Tuner is active.
15. Harmony Footswitch
The Harmony footswitch turns the Harmony Voices on and off.
When the footswitch is lit, the Harmony Voices are enabled.
When it is not lit, they are bypassed.
16. Delay
This knob adjusts the amount of delay signal that is applied to
the vocals when the Effects Footswitch is enabled.
The three buttons select the delay time. There are selections for
Short, Medium and Long delays. Additionally, pressing the Short
and Medium buttons at the same time will select a medium-
short delay time. Pressing the Medium and Long buttons at the
same time will select a medium-long delay time.
6
Advertisement
Table of Contents
