Download Print this page

GTW MACH3 EZGO TXT Installation Instructions

Rear flip seat kit & frame only kit

Advertisement

Quick Links

Rear Flip Seat Kit & Frame Only Kit
Installation Instructions for
Will Fit E-Z-GO
TXT
& Freedom TXT
®
®
®
INCLUDED:
*Cushions not included in Frame Only Kits
HD Bracket
Rear
Seat Back
Struts
Brackets
Seat Frame
Main Brackets
Lean Back Cushion
Seat Back
Support Bar
Footrest
Bagwell
Armrests
Footrest
Brackets
Brackets
Seat Bottom Cushion
1
Engage Parking Brake and switch the Key
Switch to the OFF position.
Remove canopy, rear struts, front lean back
cushion, and basket assembly. Retain canopy
and all hardware.
2
Install new Main Brackets as shown using
hardware retained from STEP 1. Position the
brackets with the flat plate on the outside.
Tighten hardware.
Note: if installing on a 2014 or newer cart use
bolts from HW Pack marked (2014-newer).

Advertisement

loading
Need help?

Need help?

Do you have a question about the MACH3 EZGO TXT and is the answer not in the manual?

Questions and answers

Summary of Contents for GTW MACH3 EZGO TXT

  • Page 1 Rear Flip Seat Kit & Frame Only Kit Installation Instructions for Will Fit E-Z-GO & Freedom TXT ® ® ® INCLUDED: *Cushions not included in Frame Only Kits HD Bracket Rear Seat Back Struts Brackets Seat Frame Main Brackets Lean Back Cushion Seat Back Support Bar Footrest...
  • Page 2 Tools Required: 7/16” Drill Bit Locate the outer holes in the frame under the rbagwell. Using a 7/16” bit, drill through hole and into bagwell. Drivers Side 17mm Socket & Wrench A) Mount the Bagwell Brackets in the newly drilled holes using the 10x40mm bolts from Pack 1.
  • Page 3 #3 Phillips Tip, 17mm Socket, & 17mm Wrench Place Seat Back Support Bar in rear of Seat Frame as shown. A) Using 10x70mm bolts and Rubber Spacers from Pack 2, attach the Arm Rests to the rear of the Seat Frame and Seat Back Support Bar.
  • Page 4 17mm Socket & Wrench Attach bottom of Armrests to Footrest using the Footrest Brackets and 10x70mm bolts from Pack 3. Note: You can now fully tighten all seat kit hardware. 10mm Socket or Wrench Using the hardware from Pack 4, install the Seat Back Brackets to the Lean Back Cushion.
  • Page 5: Installation Complete

    Textron’s trademarks and products is only for purposes of identifying golf carts with which this GTW product is compatible. GTW products are aftermarket parts and are not original equipment parts. GTW is not connected or affiliated with or sponsored by Textron® or E-Z-GO®.

This manual is also suitable for:

01-146