DigiTech STUDIOQUAD Owner's Manual page 7

Studio Quad Owner's Manual
A CC indicator in each group tells whether the indicated
Parameter is set up to be continuously controlled ( "continuous
control" includes internal LFOs, dynamic modifiers, and MIDI
continuous controlller data). Directly below each section is a
CHANGED indicator that lights to indicate that the Parameter
has been changed but not stored.
1f) Input Level / Clip Meters - The bottom center of the display is
occupied by the Input Level and Clip meters. These meters
show the input level of each channel, and use a peak detector
action to display the highest levels at the inputs. The Clip indi-
cator at the end of each meter shows whether the input signal
is being clipped at the analog input section (pre-digital).
1g) Effect Routing Matrix - The Effect Routing Matrix shows the
signal flow of the currently selected Program. This matrix
includes boxes that represent each effect module along with
lines that indicate how those effects are connected to inputs,
outputs and each other. If an effect module is bypassed, a
line appears through that module's box in the Matrix.
When in FX Edit mode, the box that represents the currently
selected effect module will flash. Likewise the Modifier module
flashes the MODIFIER indicator, the Input Mode flashes Input
Routing indicators and the Output Mode module flashes the
Output Routing indicators.
2) PROGRAM BUTTON - Selects Program mode for Program selec-
tion. The Data Wheel is used to select a program for loading. The
Program button can also be used to toggle between the User or
Factory Program Banks. The active Program Bank is shown in the
display by the Factory / User indicators (see item 1b).
This button is also used in conjunction with the FX Edit button to
access the Compare mode. See pg. 16 for more information.
3) FX EDIT BUTTON - Selects FX Edit mode for Program modification.
If you continue to press this button, you will scroll through each
individual effect module, the Modifiers module and the Input/Output
modules.
This button is also used in conjunction with the Program button to
access the Compare mode. See pg. 16 for more information.
4) PARAMETER BUTTONS - The Parameter buttons (buttons 1-4) are
used to select the Parameter or Utility item you want to edit. In
Program mode, they can also be used to enter the FX Edit mode's
1st, 2nd, 3rd, or 4th module.
5
Section 1 - Setting Up