K&H 100537803 Instructions For Use

Assembly
Here are some tips when assembling your Kitty Sill:
1. Place the Kitty Sill perpendicular to the floor with the screw holes facing up.
2. Put the legs into the corresponding holes.
3. Push hard with a downward motion toward the floor.
4. Legs will click into place.
Washing Instructions
1. Unplug & remove the internal Pet Bed Warmer (heated model only).
2. Remove the cover and wash it on the gentle cycle with cold water.
3. Line dry or use the no-heat cycle on your dryer.
Testing Your Thermo-Kitty Sill
You can test the sill's heating pad by placing a large pillow on top of it. After about 20 minutes, feel under the pillow. It
will feel warm, not hot. DO NOT use an extension cord during this test.
The surface of the bed will be about 15°F above ambient air temperature until the pet lies on the bed. Then it will warm to
about 102°F, which is the natural body temperature of dogs and cats
Instructions For Use