Page 2
Patent applications: International PCT/CA93/00099 lightning storms or wind storms to prevent Canada: 2,090,948, Japan 1994-502785, Europe: 92914139.8 damage. DigiTech and the DigiTech logo are registered trademarks of DOD Electronics Corporation RPM-1 and the logo are trademarks of IVL Technologies Ltd.
Page 3
“animation”, distortion circuitry to simulate overdriven so the rotating speaker cabinet was born. The sounds, the DigiTech RPM-1 is unique in that it rotating speaker sound became synonymous uses a vacuum tube analog distortion pre-amp.
Page 4
Front Panel Power Switch Rotor Acceleration Turn on the RPM-1 before your mixer or ampli- Because the low-frequency rotor in a rotating fier, or turn down volume on mixer or amp if speaker cabinet is much larger than the horn, it you are going to switch the RPM-1 on or off.
Page 5
If your instrument is out- Footswitch sweep the pedal from its minimum to maximum putting a very hot signal, Stereo 1/4” phone jack for the DigiTech position to calibrate the response. the 12AX7A tube will be FS300 Footswitch (included) compressing and adding...
Page 6
Keep in mind that different instruments may require slightly different guitar through a pre-amp or a guitar processor settings, especially in the adjustment of the Drive control. (such as the DigiTech GSP series), with the RPM-1 in the effects loop, or at the end of the Drive Horn Speed Rotor Accel.
Page 7
For tube-amp distortion for rhythm guitar, turn What is a rotary speaker? up the Drive control. This will give a warm dis- tortion similar to classic tube amplifier / bass speaker cabinet combinations. A rotating speaker cabinet consists of a high frequency compression driver and a low frequency speaker, whose sound is directed through Keyboard sounds mechanical deflectors spun by motors.
Page 8
In no event shall DigiTech or its dealers be liable for special or consequential damages or from any delay in the performance of this warranty due to causes...
Need help?
Do you have a question about the RPM1 and is the answer not in the manual?
Questions and answers