Section Four - Other Functions; Optional Expression Pedal - DigiTech RP70 Owner's Manual

Section Four - Other Functions

Optional Expression Pedal

The rear panel of the RP70 includes an input for an Expression Pedal. Any passive volume pedal
can be used as an Expression Pedal with the RP70. Connect the output of a passive volume pedal
to the Control In jack on the RP70. The Expression Pedal can be assigned in each preset to
control the Volume, Wah, DigiTech
time with your foot. When a parameter has been assigned to the Expression Pedal, a program-
mable minimum and maximum value can also be assigned. The procedure for assigning a parameter
to the Expression Pedal is as follows:
Press either Edit Up button until the Expression LED lights up. An effect LED will also light
1.
indicating which effect the Expression Pedal is currently assigned to.
Press either Value Up/Down button until your desired effect's LED is lit in the matrix. The
2.
Expression LED will stay lit during your selection and the Display will show a two-digit char-
acter value to describe the effect parameter that the Expression Pedal is assigned to.
3. Once you have assigned a parameter, you can set the control range of that parameter. Press
the Edit Up button again. The number value shown is the minimum parameter value – this is
the value that will be reached when the Expression Pedal is rocked back (toe up).
Press the Edit Up button again. The number value shown is the maximum parameter value
4.
– this is the value that will be reached when the Expression Pedal is rocked forward (toe
down).
5. Use the Store procedure (see page 18) to save your changes to the preset.
32
Whammy , YaYa
® TM TM
, or one of several other parameters in real