Auto Wah - DigiTech RP-20 VALVE User Manual

Section - 4 Editing Modules
FX Level
Dry Level
Balance
Min Shift
Max Shift
Min Detune
Max Detune
Pedal
Out
Pan

Auto Wah

Break out the Bell-bottom jeans and the Disco mirror balls, because the Auto-Wah is here to play. The Auto Wah is a great effect use when you
want a nasally wah-type effect, but you don't want to do the leg work. The Auto Wah utilizes a sensitivity detector that reads the input signal,
then simulates the action of a wah pedal.
Auto Wah Effect Parameters
Auto Wah On/Off
FX Level
Sensitivity
50
the module if the dry level is turned up.
This parameter lets you select the overall FX level mix of the Whammy Effect module. Ranges from: Off to 100%.
This parameter lets you select the amount of Dry signal that is included in the Whammy effect. Ranges from: Off to
100%.
This parameter allows you to pan the Dry signal either to the Right or the Left in the stereo soundfield. Ranges from
Left 99 to Right 99.
This parameter sets the minimum pedal shift level of the Whammy effect. Ranges from: -72 (6 octaves down), to 24 (2
octaves up).
This parameter set the maximum pedal shift level of the Whammy effect. Ranges from: -72 (6 octaves down), to 24 (2
octaves up).
This parameter sets the minimum pedal level of detune effect. Ranges from: -50% (down 50 cents), to 50% (up 50
cents).
This parameter sets the maximum pedal level of detune effect. Ranges from: -50% (down 50 cents), to 50% (up 50
cents).
This parameter is used for the assignment of an expression pedal. This parameter also shows the pedal travel range.
Ranges from: 0 to 100
This parameter is used to set the overall output level of the Whammy module. Ranges from: 0 to 100%
This parameter is used to position the Whammy effect in the Stereo soundfield. Ranges from: Left 99 to Right 99.
Turns the Auto Wah module on or off. When the module is turned off, the signal will continue to pass through the
module.
This parameter lets you select the overall FX level mix of the Auto Wah Effect module. Ranges from: Off to 100%.
This parameter adjusts the sensitivity of the detection of the automatic wah. The higher the sensitivity is set, the wider
the Wah range will be. Ranges from: Off to 100%.
RP-20 Valve
User Guide