Recording Overdubs - DigiTech JAMMAN Owner's Manual

Recording Overdubs

Once a loop phrase is recorded, you can add overdubs over the top of it.
Overdubs can only be recorded to Loop phrases and not to Single phrases.
1. Use the
to select a previously recorded Loop phrase, or use a newly recorded
phrase that has not yet been stored. The
previously recorded phrase is selected. If the
have selected a loop on the optional memory card.
2. Press the
status LEDs will light solid green and the phrase will begin playing.
3. Press and release the
overdub recording. This footswitch and the
now light solid yellow and any audio introduced on the selected input
will be added to the audio playback.
4. When you have an overdub you are happy with, press the
Rec/PLaY/oVeRDUb
playback (this footswitch and the
You can continue adding overdubs by continuing to press the
footswitch. Each time an overdub is added, the last overdub is
oVeRDUb
merged with the original loop and it can no longer be undone using the
Undo functions (see page 42).
Once you are finished with overdubbing, press the
stop playback/overdubbing.
NOTE: Changing loops discards any overdubs that have not been stored to
memory. Storing overdubs will remove the ability to undo or clear overdubs.
40
butons or the
LooP SeLect
Rec/PLaY/oVeRDUb
Rec/PLaY/oVeRDUb
footswitch to disable overdubbing and continue
LooP UP/LooP DoWN
LooP
footswitch. This footswitch and the
footswitch again to begin
oVeRDUb
status LEDs will light solid green).
PLaY
footswitches
LED must be lit if a
LED is lit, you
caRD MeM
status LEDs will
Rec/PLaY/
footswitch to
teMPo/StoP
PLaY