Advertisement
7. Pedal Release Pins
These two pins are spring-loaded hinges that hold the pedal in place.
Push these pins in to release the pedal from the pedal chassis exposing
the battery compartment. (See battery replacement diagram.)
8. Pedal
Press the pedal to turn the effect on and off.
9. Out 1(Mono) Jack
Connect this output to a single guitar amplifier when only one amp is
being used.
10. Indicator LED
This LED lights when the effect is turned on. If the LED becomes dim
or does not light when the cables are connected, the battery needs to
be replaced.
11. Out 2 Jack
Connect this output to a second amplifier for stereo reverb. Stereo is
the best way to get the most effective reverb experience from the
DigiVerb pedal.
Advertisement
