La Crosse Technology 616-146-INT Manual

For Proper set up:
1. Insert 2-AA batteries into your outdoor sensor.
2. Insert the 5 volt power cord into a wall outlet, then into the clock. Install 2-AAA batteries for backup
time and date.
3. After 5 minutes, place the sensor outside in a shaded location. Configure basic settings
For Atomic time:
• The backlight and USB charging port will momentarily turn off while the clock searches for the atomic
signal.
• After the initial search, your clock will only search for the atomic signal after midnight.
• The atomic time signal icon (tower) will flash while searching, and be solid when connected.
• Press -/TIME button anytime, to manually search for the Atomic time signal.
• For information about WWVB visit: http://bit.ly/AtomicTime
Backlight Projection Intensity:
• Power cord is required for constant projection.
• Press and release the SNOOZE/LIGHT button to adjust the projection HI-LOW-OFF.
Note: This will adjust the backlight at the same time.
• If operating on battery power, press the SNOOZE/LIGHT button to activate the projection for 10
seconds.
Projection Rotation:
• Press the PROJECTION button to rotate the projection image 90 degrees.
• Press the PROJECTION button again to rotate another 90 degrees. Projection: Modes Time,
Temperature
1. Hold, then release the PROJECTION button to switch projection modes.
2. Watch the projection image to view the changes. Projection Modes:
• Time and Outdoor Temperature: alternates every 5 seconds (default)
• Time only • Outdoor Temperature only
• Power cord is required for constant backlight.
• Press and release the SNOOZE/LIGHT button to adjust the backlight HI-LOW-OFF.
Note: This will adjust the projection at the same time.
• If operating on battery power, press the SNOOZE/LIGHT button to activate the backlight for 10
seconds