La Crosse Technology S82967-INT Manual

Below Proper set up:
1. Insert 2-AA batteries into your Outdoor Sensor.
2. Insert the 5 volt power cord into an outlet, then into your station. Optional: Insert 2-AA batteries for
backup.
3. Adjust time and date settings on your station.
4. Once the Outdoor Sensor is reading to your station, place it outside in a shaded location.
Note Proper MOUNTING: WHERE DO I POSITION MY SENSOR & STATION?
• Watch sensor mounting video: http://bit.ly/TH_SensorMounting • Place your thermo-hydro sensor at
least 6 feet off the ground.
• For accurate temperature readings your sensor needs to be shaded from the sun and in a well-
ventilated area. Trapped moisture will cause inaccurate readings.
• Mount your sensor vertically to allow moisture to drain out the bottom.
• Preferred location is on a north facing wall under an eave or deck rail.
• Avoid placing near a metal roof that will cause it to read high on sunny days.
• Avoid other sources of heat such as soffit vents, and window or door frames.
• For accurate humidity readings, avoid placement near vegetation and lakes or other bodies of water
when possible.
• Maximum transmission distance from your thermos-hydro sensor to your station, in open air is 300
feet (91 meters).
• Insert the mounting screw through the front of the transmitter and into the wall. Tighten the screw to
snug (do not over tighten).
Note: This unit does have an Auto dim:
WHAT IS AUTO DIM BACKLIGHT? AUTO DIM allow you to set a time for your backlight to dim to level 1
and then return to level 5. This is a handy feature to dim the backlight at the same time every night for
sleep. Set Auto Dim (Hour only).
1. Hold the AUTO DIM button 2 seconds to enter dimmer set mode. AUTO DIM OFF will show.
2. Press the + or – buttons to turn dimmer (ON). AUTO DIM ON will show.
3. Press the AUTO DIM button to select start time (Hour) for dimmer. START TIME and the hour will
flash.
4. Press the + or – buttons to change the hour for the dimmer to be low light level.