Advertisement
Quick Links
If there is no AP mode option with your WAVLINK router, here
are the instructions for you.
It requires change the LAN IP of your WAVLINK router to an IP address on the same network
segment of the main router. This IP address should be outside the main router's DHCP range.
For example, if the LAN IP of your main router is 192.168.19.1, the DHCP range is
192.168.19.100-192.168. 200 .
Then you can set the LAN IP address of your WAVLINK router to 192.168.19.2, the same segment
but not in the range of 192.168.19.100-192.168.19.200.
1.
Log into the web management page of your main router to confirm the LAN IP and DHCP
range of the main router. Assume that the LAN IP address of the main router is 192.168.19.1, and
DHCP range 192.168.19.100-192.168.19.200 as the image below shows
2. Log into the web-based management page of the WAVLINK router.
3. Go to LAN setup to change the LAN IP of your WAVLINK router to 192.168.19.2 ,make sure the
segment of your WAVLINK is same as the main router's . Then disable the "DHCP" server of your
WAVLINK router as below image shows.
Advertisement
Related Manuals for Wavlink 531G3
Summary of Contents for Wavlink 531G3
- Page 1 2. Log into the web-based management page of the WAVLINK router. 3. Go to LAN setup to change the LAN IP of your WAVLINK router to 192.168.19.2 ,make sure the segment of your WAVLINK is same as the main router’s . Then disable the “DHCP” server of your...
- Page 2 4. Connect the WAVLINK router to your main router from LAN port to LAN port via an Ethernet cable. NOTE: After change the LAN IP of the WAVLINK router, you will need to log in to the WAVLINK router with the new IP address 192.168.19.2 you set.
Need help?
Do you have a question about the 531G3 and is the answer not in the manual?
Questions and answers
HOW TO BLOCK A DEVICEIN WN 531g3