CoverCraft UVS100 UV11015BL Installation Instructions

(Optional storage bag shown)
Installation Instructions
IMPORTANT NOTICE
UVS100® Custom Sunscreens
area on some vehicles. Windshield pillar post size and an-
gle, rearview mirror shape and size, and additional sensors
can prevent some Sunscreens from providing total blackout
coverage.
STEP 1
Unfold your UVS100® Custom Sunscreen with the reflective side
facing outward and place it as flat as possible onto the dash area.
If there are assist handles on the windshield pillars, make sure
the Sunscreen fits in front of them. Then slide it forward until
it reaches the bottom of the windshield ahead of the defroster
vents.
STEP 2
With both hands, lift the top of the UVS100® Custom Sunscreen
into the windshield area.
NOTE: Be careful to not bend the corners while installing, as
damage to the inner insulator may occur.
STEP 3
Pull down each sun visor to hold the UVS100® Custom Sunscreen
in place. In some cases, the Sunscreen may not reach all the way
to the windshield pillars. This additional space is necessary to be
able to install the Sunscreen without damaging it.
REMOVAL
Simply reverse the installation steps, fold the unit and store in
the trunk or under a seat.
do not cover the entire glass