Quadra-Fire SAPPHIRE SERIES Owner's Manual

Quadra-Fire SAPPHIRE SERIES Owner's Manual

Direct vent room heater
Table of Contents

Advertisement

Quartet Front
• Important operating and
maintenance instructions
included.
WARNING: If the information in these
instructions is not followed exactly, a fire
or explosion may result causing property
damage, personal injury, or death.
• Do not store or use gasoline or other flam-
mable vapors and liquids in the vicinity of this
or any other appliance.

• What to do if you smell gas

- Do not try to light any appliance.

Do not touch any electrical switch. Do not
use any phone in your building.
- Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
- If you cannot reach your gas supplier, call
the fire department.
• Installation and service must be performed
by a qualified installer, service agency, or the
gas supplier.
Installation and service of this appliance should be
performed by qualified personnel. Hearth & Home
Technologies suggests NFI certified or factory-trained
professionals, or technicians supervised by an NFI
certified professional.
www.quadrafire.com
SAPPHIRE
DIRECT VENT ROOM HEATER
Owner's Manual
Installation and Operation
Model:
839-1390
839-1440
839-1460
SAPPH-D-CSB
SAPPH-D-CWL
CAUTION
DO NOT DISCARD THIS MANUAL
• Read, understand and
follow these instructions
for safe installation and
operation.
• Do not touch glass until it is cooled
• NEVER allow children to touch glass
• Keep children away
• CAREFULLY SUPERVISE children in the same room as
• Alert children and adults to hazards of high temperatures
High temperatures may ignite clothing or other
• Keep clothing, furniture, draperies and other combustibles
In the Commonwealth of Massachusetts:
• installation must be performed by a licensed plumber or gas
See Table of Contents for additional Commonwealth of Mas-
sachusetts requirements.
This appliance may be installed as an OEM installation in manufactured home (USA
only) or mobile home and must be installed in accordance with the manufacturer's
instructions and the manufactured home construction and safety standard, Title 24
CFR, Part 3280 or Standard for Installation in Mobile Homes, CAN/CSA Z240MH.
This appliance is only for use with the type(s) of gas indicated on the rating plate.
250-7233H
Portland
Tested and
O-T L
Listed by
Oregon USA
C
US
OMNI-Test Laboratories, Inc.
• Leave this manual with
party responsible for use
and operation.
WARNING
HOT SURFACES!
Glass and other surfaces are
hot during operation AND
cool down.
Hot glass will cause
appliance
flammable materials.
away.
fitter.
R
Solitaire Front
burns.
September 1, 2008

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SAPPHIRE SERIES and is the answer not in the manual?

Questions and answers

Summarization of Contents

Listing and Code Approvals
Appliance Certification
Details the product's certification by testing laboratories and standards.
Glass Specifications
Information on the ceramic glass used in the appliance and replacement guidelines.
BTU Specifications
Provides input and output BTU ratings for different vent configurations and gas types.
High Altitude Installations
Guidelines for installing the appliance at higher elevations and required input adjustments.
Non-Combustible Materials
Definition and criteria for materials considered non-combustible.
Combustible Materials
Definition and criteria for materials considered combustible.
Massachusetts Installation Requirements
Specific installation rules for Massachusetts, including CO detectors and signage.
Getting Started
Design and Installation Considerations
Key factors to consider before beginning the installation process.
Tools and Supplies Needed
A list of tools and materials required for installation.
Inspect Appliance and Components
Procedures for checking the appliance and its parts for damage before installation.
Appliance Location and Clearances
Selecting Appliance Location
Guidance on choosing the appropriate location for the appliance.
Clearances to Combustibles
Required minimum distances from the appliance to combustible surfaces.
Termination Locations
Vent Termination Minimum Clearances
Specifies the minimum safe clearances for vent termination points.
Vent Information
Venting Components
Lists approved components for the venting system.
Use of Elbows
Guidance on using elbows in the vent system configuration.
Measuring Standards
Defines how measurements for vent pipe lengths are taken.
How to Use the Vent Graph
Instructions for interpreting vent graphs to determine horizontal run lengths.
Venting Guidelines
General rules and requirements for vent system installation.
Horizontal Termination Installation
Steps for installing horizontal vent terminations.
Vertical Termination Installation
Steps for installing vertical vent terminations.
Cathedral Ceiling Installation
Specific procedures for installing venting through a cathedral ceiling.
Class A Metal Chimney Venting
Instructions for connecting the appliance to a Class A metal chimney.
Existing Masonry Chimney Venting
Procedures for adapting the appliance for use with an existing masonry chimney.
Gas Information
Fuel Conversions
Procedures and precautions for converting the appliance between natural gas and LP.
Valve Regulator Replacement
Steps for replacing the gas valve regulator assembly.
Gas Pressures
Required inlet and manifold gas pressures for proper appliance operation.
Gas Connection
Instructions and safety precautions for connecting the gas supply line.
Electrical Information
Wire Size Recommendations
Guidance on selecting appropriate wire gauge and maximum lengths.
Connecting to the Appliance
Instructions for wiring the appliance, including thermostat and switch connections.
Standing Pilot Ignition System Wiring
Wiring diagram and details for the millivolt control valve system.
Appliance Setup
Remove Shipping Materials
Steps to remove packaging and protective materials from the appliance.
Top and Rear Vent Conversion
Instructions for converting the appliance between top and rear venting configurations.
Grille Cover Plate Installation
Steps for installing the optional top grille cover plate.
Installing Approved Accessories
Guidance on installing approved optional accessories for the appliance.
Front Installation
Instructions for installing or removing the appliance's front panels.
Hearth Legs Installation
Procedures for installing hearth legs, noting clearance implications.
Positioning the Logs
Correct placement of logs for proper appliance operation and appearance.
Mineral Wool Installation
Instructions for placing mineral wool or embers for visual effect.
Glass Door Assembly Installation
Steps for removing and replacing the appliance's glass door assembly.
Blower Installation
Detailed instructions for installing the optional blower unit.
Operating Instructions
Before Lighting the Appliance
Pre-lighting checks and safety precautions.
Appliance Controls Overview
Explanation of the function of various control knobs and switches.
Lighting the Appliance
Step-by-step instructions for safely lighting the pilot and main burner.
After Appliance is Lit
Information on initial burn-in procedures and expected operational phenomena.
Frequently Asked Questions
Answers to common issues encountered during operation.
Maintaining and Servicing Appliance
Maintenance Tasks Checklist
A comprehensive checklist of inspection and maintenance tasks.
Reference Materials
Appliance Dimension Diagram
Diagrams showing the physical dimensions of the appliance.
Vent Components Diagram
Visual representation of the various vent system components.
Vent Components List
A catalog of available vent system parts from different manufacturers.
Service Parts List
An exploded view and list of service parts for the appliance.
Optional Accessories
A list of available optional accessories for the appliance.

Table of Contents

Save PDF