Apromise GL0001 Installation Instructions

Items included：
4 Glass panels
4 Top Brackets with set screws
4 Bottom Brackets with set screws
and SUS304 plates and footpads
Tools needed：
Phillips screwdriver or other similar screwdriver
Instructions for Wind Guard ：
1. Carefully remove the panels from packaging and inspect
for any damage such as chips or cracks. Place glass panels upside
down on a soft flat surface to prevent any damage.
2. Loosen set screws in one of bottom bracket and slide two glass panels into brackets.
Ensure silicone pad is in place on tip of set screws and tighten a
little. Go on for the other three bottom brackets in the same way.
3. Flip the sub-assembly down and install the Top brackets in the same way,
then tighten all the screws when finished all the assembly.
4. Flip fully assembled wind guard over and place on the fire
pit and centralize around burner.
Warnings：
Hot glass may cause burns.
Do not touch glass until cooled.
Never allow children to touch the glass.
Wind Guard Installation Instructions
(For Model:GL0001,GL0002,GL0003,GL0006,GL0008,GL0009)
TM
Top Bracket
Silicone Washer
Set Screw
Bottom Bracket
SUS304 Plate
Footpad
Screw
Glass Panel