Aquasana Claryum AQ-5300R Owner's Manual

Protect your investment and save money
with our Water for Life program.
Discounted
Extended
Warranty Replacements
CONTACT US TO LEARN MORE 866-662-6885
waterforlife@aquasana.com
System tested and certified by WQA
to NSF/ANSI Standard 42, 53, and
401 for the reduction of the claims
specified on the Performance Data
Sheet and at www.WQA.org.
The recommended replacement frequency for the AQ-5300R is every 6 months or 600 gallons of use.
Use only certified, genuine Aquasana replacement filters for continued contaminant removal and
system performance.
Aquasana, Inc.
6310 Midway Road
Haltom City, Texas 76117
866.662.6885 USA
877.332.7873 Canada
www.aquasana.com
INSTALLATION STEPS
1
Shut off the cold water valve
sink. Release the pressure from the system
by turning on the dedicated faucet. Once
there is no longer any water flowing, you
can proceed with replacing the filters.
2
Unbox filter replacements
plastic. Each filter is color coded to match
the circle indicator on each filter housing.
Remove each filter housing
3
housing to the left. Pull down to detach. Ensure the filter housings are not on
an angle while removing. This may result in damage to the o-ring.
4 Holding the filter housing over the sink,
open it by turning the bottom counter-
clockwise. Pour excess water down sink
drain. Pull down on dirty filter to
disconnect it from the filter housing.
Continue this step for the second and third
filter housing. While the housing is open,
inspect each o-ring for damage. If damaged,
replace immediately. If misaligned, gently
move the o-ring into place.
NOTE: If filter housing is too tight to disconnect by hand, please use the plastic
wrench included with original system.
NOTE: Must replace housing every 5 years or risk property damage from leaks.
Call 866-662-6885 to order.
Do not use with water that is microbiologically unsafe or of unknown water
quality without adequate disinfection before or after the system.
Free No
Shipping Contract
For the full list of
contaminants filtered,
scan to view the
Performance Data Sheet
on Aquasana.com.
under the
and remove
from the system manifold by turning the filter
AQ-5300R
Under Sink Water Filter
Claryum
REPLACEMENT
Owner's Manual
100362138
For use with AQ-5300
6
Reattach filter housing
connection points are correctly aligned, then push the filter housing
up while turning clockwise. Continue this step for the second and third
filter housing. Ensure all filter housings are attached and locked in
place. Ensure the filter housings are not on an angle while reattaching.
This may result in damage to the o-ring.
Open battery door
7
When inserted correctly, system will beep five times and blink red.
Once all filter housings
8
replaced and reattached, slowly turn
water valve on. Turn off faucet and
inspect for leaks. Then, flush system
for 10 minutes before drinking.
NOTE: Do not drink flushed water.
3-Stage
®
5 Press new replacement filter
the top of the filter housing using
the appropriate color coded filters.
Then, reconnect the bottom of the
filter housing to the top half. Ensure
connection points are correctly
aligned, then turn clockwise to
tighten. Continue this step for the
second and third filter housing.
NOTE: Do not use tools to
tighten. Hand tighten only.
to bottom of the system manifold. Ensure
and remove old battery. Insert new battery.
have been
Scan to view the
Claryum 3-Stage
®
filter replacement video.
to