Torbal ATN1100 Getting Started

Getting Started
ATN1100 | ATN2100 | ATN110 | ATN210
1. Carefully remove the scale, pan, and all components out of the
packaging. Place them on a stable surface where the scale will not be
compromised by any mechanical vibrations or high air movements.
2. After removing the pan base and the pan from their packaging,
carefully install the draft ring (3 – ATA110 and ATA210), and pan base
(2) onto the scale by seating it on the pan support located in the
middle of the scale. Once the pan base has been installed, carefully
place the pan (1) on the base
The scale is equipped with 4 nickel–metal hydride 2700mAh rechargeable batteries.
The batteries are installed prior to shipping. Charging is disabled by default.
3. To enable battery charging press the "MENU" key. Select "" by pressing the "T" key.
4. Select "" and "" by pressing the T key.


1

Caution!
Always disable charging before
installing disposable batteries
Charging non-rechargeable,
alkaline batteries can be
hazardous and cause damage to
scale.