Checking The Codes; Programming Master Power; Programming The Power Key For Master Power; Operating Master Power - One for All PVR 6 User Manual

PVR 6 Owners Manual.fm Page 9 Monday, December 20, 2004 11:17 AM
NOTE: In the search mode, the remote control
will send IR codes from its library to the
selected device, starting with the most
popular code first.
5. To lock in the code, press and release
SET. The LED will blink twice.
6. To search for the codes of your other
devices, repeat steps 1 through 5, but
substitute the appropriate device key
for the device you are searching for.

CHECKING THE CODES

If you have set up the remote control using
the Searching For Your Code procedure (on
the previous page), you may need to find
out which four-digit code is operating your
equipment.
For example, to find out which code is
operating your TV:
1. On the remote control, press TV once.
2. Press and hold SET until the LED (red
light) blinks twice, then release SET.
3. Enter 9 9 0. The LED will blink twice.
4. To view the code for the first digit,
press 1 once. Wait 3 seconds, count the
LED blinks (e.g., three blinks = 3) and
write down the number in the leftmost
box in the TV code boxes on page 7.
NOTE: If a code digit is 0, the LED will not
blink.
5. Repeat step 4 three more times for
remaining digits. Use 2 for the second
digit, 3 for the third digit, and 4 for the
fourth digit. Write down the code
digits in the remaining TV code boxes
on page 7.
6. To check for codes of other devices,
repeat steps 1 through 5, but substitute
the appropriate device key for each
O
WNER
device you are checking. Write down
the device's code digits in the
appropriate code boxes on page 7.
PROGRAMMING MASTER
POWER
In its default state, the POWER key on the
URC-6131 remote control will individually
power your home entertainment devices on
or off. However, you can also program a
Master Power function onto the POWER key
that will sequentially turn on or off all the
devices with a single key press.
P POWER K
ROGRAMMING THE
M P
ASTER OWER
1. Press and hold SET until the LED (red
light) blinks twice, then release SET.
2. Enter 9 9 5. The LED will blink twice.
Then press POWER once.
3. For the first device you want in the
power on sequence, press its device
key (e.g., CBL/SAT) once.
4. Repeat step 3 up to five more times to
add desired devices to the power-on
sequence.
5. To save the settings and exit the
program, press and hold SET until the
LED blinks twice, then release SET.
O M P
PERATING ASTER OWER
1. After programming, point the remote
control at the devices and press POWER
for at least 2 seconds to sequentially
turn on or off your devices.
NOTE: When you press POWER for less than 2
seconds, the remote will only send a power
command to the currently-selected device.
This allows you to still individually power
devices on or off.
Checking the Codes
' M
S ANUAL
EY FOR
9