NICOR Prime Chime Plus PRCP1 Installation Instructions

WARNING - RISK OF SHOCK
1. This fixture is to be installed by only a qualified electrician.
2. This fixture is to be used at 120V AC/60Hz power supply only.
3. This fixture is designed for use in a circuit protected by a fuse or circuit breaker.
4. Turn off the power supply at the fuse or circuit breaker box before you install this fixture.
5. Turn off the power supply again when you perform maintenance.
6. Double check all connections to be sure they are all tight and correct.
7. Operation environment: to be installed indoors under dry and ventilated environment. It should NOT be installed damp locations or
environment with high temperature. Installation of this fixture should be kept away from other electrical devices.
What's In The Box
One (1) Prime Chime Plus
Tools Needed
The Prime Chime Plus requires very few tools for installation. A screwdriver and a pair of wirecutters will be
required to install the chime.
Junction Box
Pre-install a dual voltage box (CARLON Model#SC200DV or equivalent, not provided) before installation of this device.
Installing a single Prime Chime Plus
1
Carefully unpack fixture and faceplate.
3
Connect low voltage bell wires (18ga or 22ga) into
ports 1(+) and 2(-).
Two (2) Lighted Doorbell Buttons
2
Connect line voltage wiring (120VAC, 18ga or greater)
per the diagram.
Junction
Box
4
Install chime into junction box using four (4) included
screws.
Prime Chime Plus
INSTALLATION INSTRUCTIONS
One (1) Hardware Pack
Make sure all power is turned off before beginning installation
120V/60Hz only
Black (Line) Black (Line)
White (Neutral) White (Neutral)
Model:
PRCP1