NICOR Prime Chime Plus PRCP2 Installation Instructions

WARNING - RISK OF SHOCK
1. This xture is to be installed by only a quali ed electrician.
2. This xture is to be used at 120V AC/60Hz power supply only.
3. This xture is designed for use in a circuit protected by a fuse or circuit breaker.
4. Turn o the power supply at the fuse or circuit breaker box before you install this xture.
5. Turn o the power supply again when you perform maintenance.
6. Double check all connections to be sure they are all tight and correct.
7. Operation environment: to be installed indoors under dry and ventilated environment. It should NOT be installed damp locations or
environment with high temperature. Installation of this xture should be kept away from other electrical devices.
What's In The Box
One (1) Prime Chime Plus
Tools Needed
The Prime Chime Plus requires very few tools for installation. A screwdriver and a pair of wirecutters will be
required to install the chime.
Junction Box
Pre-install a dual voltage box (CARLON Model#SC200DV or equivalent, not provided) before installation of this device.
Video Doorbell Compatibility Notes
For all video doorbells:
1) To ensure proper operation of the PRCP2, no more than one video doorbell should be attached (Front Door or Back Door)
2) Make sure the video doorbell is fully charged prior to installation. Low battery levels may cause abnormal performance of the PRCP2.
3) Wiring must not exceed the following: 70' from doorbell to rst unit. 200' total length if installing more than one PRCP2
4) A "power" or "diode" kit should not be installed when using the NICOR PRCP2. It is designed to provide the proper voltage for
compatible video doorbells.
For Ring products:
Adjust the "Ring tone length" in the App to 2 seconds to avoid multiple chime cycles (see Ring instructions for details).
NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393 www.nicorlighting.com June 30, 2023 5:00 PM PRCP2 Rev - Page 1 of 5
Two (2) Lighted Doorbell Buttons
Prime Chime Plus
INSTALLATION INSTRUCTIONS
Model:
One (1) Hardware Pack
PRCP2