Sony GXDL52H1 - 52" LCD Flat Panel Display Operating Instructions Manual page 81

Assigning a fixed IP address to the display
1
Press MENU to bring up the main menu.
2
Select "Setup" with F/f and press
3
Select "Advanced Setup" with F/f and
press .
4
Select "IP Address Setup" with F/f and
press .
5
Select "Manual" with F/f and press
6
Select an desired item to set from "IP
Address", "Subnet Mask", "Default
Gateway", "Primary DNS", "Secondary
DNS" with F/f and press
7
Set the three digit value (0 to 255) for each
of the four box with F/f on the display or
numeric keys on the remote control and
press or g.
8
Set the three digit value (0 to 255) for each
of the four boxes and press
same procedure as step 6 and select the
next desired item to set with F/f and press
.
9
After values are set for all the desired
items, select "Execute" with F/f, then
press .
Select "Execute" and press
manually.
When "Cancel" is selected, the setting will return to
the original setting.
Automatically obtaining an IP address
1
Press MENU to bring up the main menu.
2
Select "Setup" with F/f and press
3
Select "Advanced Setup" with F/f and
press .
4
Select "IP Address Setup" with F/f and
press .
5
Select "DHCP" with F/f and press
Select "Execute" and press
automatically set.
When "Cancel" is selected, the setting will not be
executed.
.
.
.
. Repeat the
. An IP address is set
.
.
. An IP address is
Note
When an IP address is not set properly, the following error
codes will be displayed in accordance with the error cause.
Error 1: Communication error between the display and the
optional adaptor such as the BKM-FW50
Error 2: The specified IP address is already used for other
equipment
Error 3: IP address error
Error 4: Gateway address error
Error 5: Primary DNS address error
Error 6: Secondary DNS address error
Error 7: Subnet mask error
Checking the automatically assigned IP
address
1
Press MENU to bring up the main menu.
2
Select "Setup" with F/f and press
3
Select "Information" with F/f and press
.
4
Select "IP Address" with F/f and press
.
The IP address currently acquired is displayed.
Setting a communication speed
1
Press MENU to bring up the main menu.
2
Select "Setup" with F/f and press
3
Select "Advanced Setup" with F/f and
press .
4
Select "Speed Setup" with F/f and press
.
5
Select a desired communication speed to
set from "Auto Detect", "10Mbps Half",
"10Mbps Full", "100Mbps Half", or
"100Mbps Full" with F/f and press
When "Auto Detect" is selected, a communication
speed appropriate for your network configuration is
automatically set.
6
Select "Execute" with F/f and press
reflect the setting.
.
GB
.
.
to
33
GB