Sony GXDL52H1 - 52" LCD Flat Panel Display Operating Instructions Manual page 78

30
GB
Note
When this item is operated, the available modes will differ depending on whether you
select by the remote control or the display. When setting this item with
control, you can select only "Display+Remote" or "Remote Only". When setting this
(ENTER)
item with
"Display Only".
"Auto Screen Adjust"
"On": The settings such as picture size and position are saved for each input
signal, and the last settings are automatically applied each time the input signals
are switched.
"Off": The "Auto Screen Adjust" is disabled even when input signals are
switched and the default settings are applied.
"Auto Shut Off":
"On": The display automatically enters the standby mode when a signal is not
input to the Video or S Video input connectors for more than about 5 minutes.
The display automatically enters the power saving mode when a signal is not
input to the DVI, HDMI, or HD15 (RGB/Component) input connectors for more
than about 30 seconds.
"Off": The display is not turned off automatically even when no signal is input
to any connector.
Tips
• While in the standby mode, press the 1 (POWER) switch on the display or the POWER
ON switch on the remote control to turn the display on. In the power saving mode, the
display is turned on automatically when a signal is input.
• This function is not available when the screen saver function is activated.
• This function is not available when "On-Screen Logo" is set to "On" using the DVI
input, HDMI input or HD15 (RGB/Component) input.
"Color Matrix": Shows pictures in natural color tones when the HD15 (RGB/
COMPONENT) IN connector of the display is connected to a video equipment.
": When the signal format is 480i(525i) or 480p(525p)
"Y/C /C
B R
": When the signal format is 720p(750p) or 1080i(1125i)
"Y/P /P
B R
Note
"Color Matrix" is available only for Component input.
"Overscan": Selects whether to display images with overscan or underscan.
"Auto": Switches automatically signal image which are supposed to be DTV to
image with overscan.
"On": Displays image with overscan.
"Off": Displays image with underscan.
Note
If "Overscan" is set to "Off," DTV signal image may be displayed like PC signal display.
Example: 480P t 720 × 480/60
"Sync Mode": Sets the mode according to the signal input at pin 13 of the HD15
(RGB/COMPONENT) IN connector. Signals can be set only to 575/50i or 480/60i.
"H/Comp": Select when a horizontal signal or a composite synchronous signal
is input.
"Video": Select when a video signal is input.
Notes
• "Sync Mode" is available only when PC signal is input to HD15 connector.
• Depending on the level of the composite synchronous signal, the image may not be displayed
correctly. In this case, change the "Sync Mode" setting.
• There are some inputs for which only synchronizing signals can be selected. In this case,
input horizontal/vertical synchronization signals through the pin 13 or 14 of the connectors.
• Sync Mode settings cannot be carried out for the input through the optional adaptors.
• This display does not support the three value sync format of 576/60p.
• When you select the video signal for the synchronous mode setting, you cannot use the PAP
function.
on the display, you can select only "Display+Remote" or
on the remote