Base Stand Assembly Instructions; Remote Control - Haier LE42B1380 Owner's Manual

Introduction

4. Base Stand Assembly Instructions

1. Put the neck on the base stand, and attach the neck with the supplied screws (5 x B4 x 16F).
2. Put the rear board on the neck, and attach the rear board with the supplied screws (2 x ST4 x 12, 2 x M4 x 12).
3. Place the TV face down on a soft and flat surface (blanket, foam, cloth, etc.) to prevent any damage to the TV. Put the rear
board on the rear cabinet of the TV , and attach the rear board with the supplied screws (4 x M4 x 12).
1. Place the TV face down on a soft and flat surface (blanket, foam, cloth, etc.) to prevent any damage to the TV. Put the stand on the TV set
2. Affix the stand in-to position with the supplied screws (4 x B4 x 22F).

5. Remote Control

Installing Batteries
1. Open the battery compartment cover on the back of the remote control.
2. Insert two 1.5V AAA size batteries observing the polarity markings inside the battery
compartment. Don't mix di
3. Close the cover.
Batteries shall not be exposed to excessive heat such as direct sunlight or fire.
- The remote control should be operated within 30 feet (7m) and 30
IR receiver at the front of the TV.
- Used batteries should be disposed of properly.
S e t p 1
Battery
Compartment
Cover
Front
Screws: 2xM4X12 Screws: 2xST4X12
Screws:
4xM4X12
Screws:4xB4X22F
fferent types or used batteries with new ones.
S e t p 2
2 x AAA Battery
Note: the pictures below are only for reference
Screws:
5xB4X16F
Back
0
to the left and right of the
S e t
46"
42"
p 3
9