The purpose of this document is to provide necessary information to help setup and installation of RSU-352 series products. To provide for safe installation and operation of the equipment, read the safety guidelines at the beginning of this manual and follow the procedures outlined in the following chapters before connecting power to RSU-352.
Doc. No: Unex-QSG-21-002 representative of Unex if you need advanced technical support. Products with an altered and/or damaged serial number. • Loss of data or software. • Products that have been updated, reworked, or improperly tested by the • Customer, or by a third party at the request of the Customer.
Page 19
The PD end PoE SPD (i.e. the surge protector) is included in the RSU package IGURE The PSE end PoE SPD is not included in Unex’s product scope and should be purchased/installed by the user. If a standalone SPD is used, the Ethernet cable length between PSE and SPD should be kept as short as possible, better not exceeding 1m long.
*1: Enclosure only without any accessory, antenna ports excluded. *2: With all accessories: V2X antennas, GNSS antenna, surge protector, mounting bracket, and earth wire. 11. Software Settings The following BSP settings are applicable for Unex software package only. Table 11: Unex BSP interface settings Function Description Ethernet Default IP address 192.168.100.3...
7: GNSS ABLE ANTENNA STATUS cat /sys/bus/iio/devices/iio\:device0/in_voltage4_raw cat /sys/bus/iio/devices/iio\:device0/in_voltage5_raw If Unex’s V2X antennas EX-53 are not used, it is the user’s responsibility to check the antenna OPEN/SHORT status. Attention Performing transmission under OPEN/SHORT conditions may • cause permanent damages to RF components.
Page 26
/usr/bin/cv2x_rrc_config.uper are uploaded on both TX and RX nodes. /usr/bin/cv2x_sw_config.txt 3.1.2 If the RSU-352 comes with Unex’s C-V2X protocol stack, then use command to check the overall GNSS system healthiness. gnss_health means the access layer (i.e., the TSF timer) has ACL_TIME_SYNC_SYNCED been successfully synchronized.
Page 27
Doc. No: Unex-QSG-21-002 3.1.3 If the RSU-352 comes without Unex’s C-V2X protocol, then use the following commands: 3.1.3.1 Check the GNSS antenna status and fix mode. For GNSS antenna status, please see GNSS A NTENNA ; for GNSS fix mode, please check the 2...
Need help?
Do you have a question about the RSU-352 Series and is the answer not in the manual?
Questions and answers