Subscribe to Our Youtube Channel
Related Manuals for poolstar Aquajack 223
Summary of Contents for poolstar Aquajack 223
- Page 1 Instruction manual Power Rating: 10W Battery: 3.7V /2000mAh Charging power: 5V DC, 1.0A Motor voltage: 3.7V DC Motor voltage：IPX8...
-
Page 2: Safety Warning
(1)The cleaner is designed to clean the swimming pool, spa. (2)Please use the original batteries and charger when using.(Only available for AquaJack 223) . (3)Only charging it when the cleaner is power off. (4)Put the cleaner into a clean and dry place. Do not expose it under the sun, or close to explosive. - Page 3 (8)Make sure the cleaner, USB lane and charger are totally dry before charging. (9)Charge the cleaner 5 hours prior to the first use.Normally cleaner can be operated about 30 minutes after fully charged. Battery disposal (1)The robot battery is a lithium battery, it must be disposed properly , please contact with your local authority for more information.
-
Page 4: Charger Connection
How to use it Assembly A. Vacuum head A-1. Round Brush B. Front filter C. Paper filter D. Motor body E. Portable handle F. Back filter G. USB charger 1. Charger connection Plug one end of the charging cable into the USB charger and one end of the Pin cover Charger Port... -
Page 5: Installation
2. Installation 2.1 Filter element assembly and body parts assembly Assemble the body parts in the direction of the arrow. “CLOSE” 2.2 Assembly of vacuum 2.3 Handle assembly head (2) Assembly of telescopic pole (1) Handle assembly (not included) Insert the entire vacuum This handle is used to clean Cleaner can be connected to a head directly into the... - Page 6 4. When to use paper filter ? There is a paper filter with shipment, it is used to collect fine dust and rubblishes; For daily Back filter cleaning, such as leaves, fruits, stone, there is no need to such a paper filter. Paper filter 5.
-
Page 7: Maintenance And Storage
6.2 Back filters cleaning (1) Press and hold the button at the front end of the back filter to remove the whole filter cover from the body; (2) Then take out the internal filter screen; (3) Clean the internal filter screen; (4) After cleaning, reinstall the internal filter screen as shown in the figure, and then assemble the filter cover on the body. -
Page 8: Troubleshooting
Troubleshooting If you have problems with your cleaner, follow the troubleshooting steps below to restore performance. Note: turn off the power before making any repairs. Problem Possible causes Solution Please Recharging The battery is low Turn off the cleaner and check the impeller to remove the garbage.
Need help?
Do you have a question about the Aquajack 223 and is the answer not in the manual?
Questions and answers