Panio PS0820 Quick Manual

Panel Operations:
1. Power-On Procedure
Steps: Press and hold the START button for 5 seconds. The power will sequentially turn on from Channel 1 to
Channel 8.
Indicator Light: After powering on, the indicator will display a green light, indicating successful activation.
2. Power-Off Procedure
Steps: Press and hold the START button for 6 seconds. The power will sequentially turn off from Channel 1 to
Channel 8.
Indicator Light: After powering off, the indicator will display a red light, indicating that the power is off.
3. Individual Channel Control
Steps: Press and hold any button (1-8) for 5 seconds. The LED HOST will display an unlock icon, allowing you to
individually control the power status of each channel.
4. Sequential Timing Adjustment
Steps: Press the EDIT button once to enter the power sequence timing adjustment mode. Rotate the dial left or
right to adjust the timing, and press briefly to confirm your selection.
TCP/IP/UDP/RS232 control codes:
TCP/IP/UDP: 192.168.1.198, port number is 5000.
RS232: Baud rate: 2400, 8 bit, none
The below equipment ID is 0, send as Hex format:
Function
All 8 channels ON
All 8 channels ON in order
Channel 1 ON
Channel 2 ON
Channel 3 ON
Channel 4 ON
Channel 5 ON
Channel 6 ON
Channel 7 ON
Channel 8 ON
All Channels OFF
All Channels OFF in order
Channel 1 OFF
Channel 2 OFF
PANIO PS0820 Quick Guide
Commands in HEX
55 01 00 10 F0 AA
55 01 00 0D F0 AA
55 01 00 01 F0 AA
55 01 00 02 F0 AA
55 01 00 03 F0 AA
55 01 00 04 F0 AA
55 01 00 05 F0 AA
55 01 00 06 F0 AA
55 01 00 07 F0 AA
55 01 00 08 F0 AA
55 01 00 10 F1 AA
55 01 00 0D F1 AA
55 01 00 01 F1 AA
55 01 00 02 F1 AA