Potter PDC 10G Installation Manual

INSTALLATION MANUAL: PDC SECURITY BELL MODULE
NOTICE TO THE INSTALLER
This manual provides an overview and the installation instructions for the PDC 10G Security Bell. All connections are
power limited and should be wired in accordance with the requirements of NFPA 70 (NEC) and NFPA 72 (National Fire
Alarm Code). Failure to follow the wiring diagrams in the following pages will cause the bell to not operate as intended.
1. DESCRIPTION
The PDC Security Bell is a DC bell designed for easy indoor and outdoor installation wherever required. The semi-flush
design has an optional waterproof backbox available.
2. TECHNICAL SPECIFICATIONS
Audibility Rating (dB at 10 ft)
RATING 6" GONG SIZE
RATED
VOLTAGE
CURRENT
12VDC 200mA
24VDC 100mA
3. INSTALLATION
1. Remove the gong.
2. Wire the bell in the circuit.
3. Mount bell mechanism on 4" square outlet box with the striker facing down.
4. Replace the gong.
5. Mount the bell a minimum of 8ft. above the floor or as close to the ceiling as possible
6. Observe the polarity when installing the bell. Polarized bells provide Red (+) and Black (-) lead wires.
Potter Electric Signal Company, LLC
8" GONG SIZE
SOUND LEVEL RATED
AT 10 FT dB CURRENT
96 200mA
96 100mA
• St. Louis, MO
5410143-REV A 12/19
firealarmresources.com
10" GONG SIZE
SOUND LEVEL RATED
AT 10 FT dB CURRENT
96 200mA
96 100mA
• Phone: 800-325-3936
SOUND LEVEL
AT 10 FT dB
96
96
• www.pottersignal.com
PAGE 1 OF 2