Advertisement
Advertisement
Table of Contents
Related Manuals for Crown PRO-FT08
Summary of Contents for Crown PRO-FT08
- Page 1 PRO-FT08...
-
Page 2: Important Safety Instructions
Dear Consumer, Thank you for your purchase of our range hood. Please make sure to read all the instructions carefully before proceeding with the installation of the range hood. IMPORTANT SAFETY INSTRUCTIONS WARNING 1. Before servicing or cleaning unit, unplug or disconnect the rangehood from the power supply. -
Page 3: Technical Specifications
TECHNICAL SPECIFICATIONS Model No.: Pro-FT08 Total power: 304W Motor power: 2x150W Led light: 2x3W Voltage: 120V Frequency: 60Hz Filter: Steel baffle filter Control: Touch control TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVEN OF A GREASE FIRE OBSERVE THE FOLLOWING: 1. - Page 4 26”-31”.
- Page 5 d temeporarily in Fixing the Decorative chimney duct 1. Carefully losen but do not separate the telescopic chimney duct pieces. 2. Arrange the electrical power supply within the dimensions of the decorative chimney flow. 3. Adjust the width of the support bracket to match the upper duct. Fix it to the ceiling using the screws (B) so that it is centered in line with your hood and at a distance from the ceiling indicated.
- Page 6 Note: The above installation guideline for references only, please contact your local dealer for an installation service.
- Page 7 REMEMBER! The distance between the top of the range and the lowest part of the range hood must be at least 25.6". If a two-part connection tube is used, the lower suction must sit outside the upper section. Do not connect the range hood exhaust to a duct used to circulate hot air or vent steam from another appliance.
-
Page 8: Description Of The Controls
USE AND CARE INSTRUCTIONS Operations 1. For optimum performance in removing cooking odors, it is recommended that you turn on your range hood prior to cooking and you leave it operating for 15 minutes after cooking. 2. Clean the surfaces of the range hood regularly using a non-abrasive detergent. 3. -
Page 9: Speed Control
3. POWER The POWER button activates the range hood. once you press the POWER button, the screen panel will fully illuminate and the other buttons on the control panel will display low illumination. Lightly press the POWER button again to turn off the range hood. Once the range hood is off, all buttons will cease to illuminate and the smoke baffle flippers will close automatically. - Page 10 General Regular Maintenance is required to ensure that the range hood functions properly. This is especially true of the grease and charcoal filters. Clean the fan and others surfaces of the range hood regularly with a cloth dipped in denatured alcohol or a non-abrasive liquid cleaner.
- Page 11 time of the bulbs.
Need help?
Do you have a question about the PRO-FT08 and is the answer not in the manual?
Questions and answers