(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This Class B digital apparatus complies with Canadian ICES-003. 1224637-2-E Kohler Co.
Page 3
Module Bracket Slot Bottom Tab 1. Install Bracket in Slots Install the bracket on the module, with the bottom tab in the bottom slot. Kohler Co. 1224637-2-E...
Page 4
Install the bridge over the vent if the vent is aligned with the bracket marks. Install the module so the bracket aligns with the bracket location marks. Connect the chain from the canister to the wheel. 1224637-2-E Kohler Co.
Confirm the top edge of the battery holder is below the rim of the module. Close the module lid and press on the front ledge until the clasp engages. Kohler Co. 1224637-2-E...
Ensure the bracket is positioned between the location marks. Ensure that the canister fully closes when the flush is complete. Observe the movement of the wheel. Ensure that the wheel does not come into contact with anything when rotating. 1224637-2-E Kohler Co.
The pads stabilize the lid to prevent false flushes when the lid is bumped. Install the tank lid. Hold your hand approximately 1″ (25 mm) above the module. The toilet will flush. Consult the troubleshooting chart for operation or performance issues. Kohler Co. 1224637-2-E...
A. Confirm nothing is interfering with use. the tank lid. Bumping the tank lid may cause the toilet to flush. B. Confirm the provided foam pads are installed on the tank’s four corners to stabilize the tank lid. 1224637-2-E Kohler Co.
Warranty ONE-YEAR LIMITED WARRANTY KOHLER plumbing products are warranted to be free of defects in material and workmanship for one year from date of installation. Kohler Co. will, at its election, repair, replace or make appropriate adjustment where Kohler Co.
Need help?
Do you have a question about the K-6418 and is the answer not in the manual?
Questions and answers