Making The Lcd Monitor Easier To See (Lcd Mode) - Panasonic Lumix DMC-LZ10 Operating Instructions Manual

Making the LCD monitor easier to
see ( LCD mode)
1 Press and hold [Q.MENU] until
quick setting screen is displayed.
2 Select indication at the right end
(initial setting: [
select mode using e/r and press
[MENU/SET].
AWB AUTO 10
2
SELECT
42
VQT1L86
Advanced-Shooting
Q.MENU
]) using q,
M
MENU
SET
MENU
EXIT
Mode
Brightness of the LCD
monitor automatically
AUTO
changes depending
POWER LCD
on brightness of the
environment.
The LCD monitor becomes
brighter and easier to see
POWER
even when taking pictures
LCD
outdoors.
This is useful
when you cannot
HIGH
get close to the
ANGLE
subject because
there is a person
in the way.
(More diffi cult to
see when looked
straight on.)
The LCD monitor returns to
the normal brightness.
• You can set LCD mode in setup menu.
( P21 )
• High angle mode is canceled if you
turn the camera off. (Same occurs in
[POWER SAVE].)
• The LCD monitor automatically returns to
normal brightness after 30 seconds when
recording in power LCD mode. Press any
button to make the LCD monitor bright
again.
• The brightness of the pictures displayed
on the LCD monitor is adjusted when
power LCD mode or high angle mode
is activated. Therefore, some subjects
may look different on the LCD monitor.
However, this does not affect the
recorded pictures.
• If the screen is diffi cult to see because of
light from the sun etc. shining on it, use
your hand or another object to block the
light.
• The number of recordable pictures
decreases when the auto power LCD,
power LCD or high angle mode is used.
Uses