With wiegand converters; usb & rs-232 configuration software for use with pcprox proximity readers, wiegand to xxx converters, andair id enroll contactless smart card read-only readers (56 pages)
Software business, school, or organization. III. Reader Setup IV. Configuring the Reader rf IDEAS products are an integral part of a variety V. Troubleshooting of solutions in every market such as healthcare, manufacturing, government, enterprise and other markets. The number of applications is ever-increasing...
1. Connector Options There are two connector options available with the reader for data input and output. The product you have purchased may need to be configured before use. The configuration software and support documents can be downloaded from our product support page at: http://www.rfideas.com/support/product-support The configuration section details the steps necessary to install the configuration utility software and update the configuration to meet your requirements.
4. Configuring the Reader To configure the Reader for operation, complete the following steps: Start the pcProx Configuration Utility software. Plug the reader into the workstation’s USB port. a. If the reader has a USB connector, verify the workstation detected the connection automatically using Windows Device Manager.
Page 5
RF IDeas shall not be liable the terms of this EULA; and (f) agree that rf IDEAS reserves all rights not for losses due to failure of any of these products, or components of expressly granted.
This warranty shall be limited to corporations or products is purely coincidental. RF IDeas believes that the repair or replacement and in no event shall rf IDEAS be liable for any loss information contained in this manual is correct. However, RF IDeas does...
Need help?
Do you have a question about the WAVE Plus Mini and is the answer not in the manual?
Questions and answers