Battery Installation - Honeywell TE923W - Deluxe Weather Station User Manual

Battery installation

• Open the battery compartment door on the back of the main unit.
• Insert four (4) AA size batteries according to the polarities shown and replace the battery
compartment door.
• Connect 7.5V AC/DC adapter provided to the main display unit and plug into the wall power
outlet.
Note: The AC/DC adaptor connection is required for automatic backlight control and a
handheld remote control functions. If the main unit operates solely on the battery power, the
auto backlight control and handheld remote control functions will be disabled.
• When placing the main unit on the table or other horizontal surface, unfold the table stand
adjusting it to the desired viewing angle.
• When mounting the main unit on the wall or vertical surface, fold the table stand back into the
unit and use the mounting hardware provided.
Placement tips
• Make sure that the main unit is locating within the operating range of all remote weather
sensors.
• Ideally the remote weather sensors should be mounted within the line of sight of the main unit.
• Transmission range may be affected by trees, metal structures and electronic appliances.
• Test reception before permanently mounting all the remote weather sensors.
Avoid placing the main unit in the following areas:
• Direct sunlight and surfaces emitting and radiating heat, such as heating ducts or air
conditioners.
• Areas with interference from the wireless devices (such as cordless phones, radio headsets, baby
listening devices) and electronic appliances.
Operation
Once the main unit is powered, the display will show all available LCD segments for a moment.
IMPORTANT: All of the display functions will be locked, allowing setting your local altitude and
pressure parameters. The locked display will show the pressure icon and abbreviation "inHg"
flashing, indoor temperature and humidity readings, default time and default sunset/sunrise time.
If pressure and altitude are not configured during this time, the unit will self-calibrate in a few
minutes and show the default settings for the pressure and altitude (sea level) and all remote
weather sensors readings.
IMPORTANT: If not set during the initial setup, the altitude cannot be adjusted or set at any other
time. In order to set the altitude, you will have to restart the main unit completely.
TE923W IM1(ENG) HONEYWELL R.pmd
15
15 4/11/08, 5:26 PM