Advertisement
Quick Links
Artome X10M
Projector Installation
1. Lock the wheels and open the
front door
4.Open the lens latch. Remove the
back cover (HEX4) and disconnect
the pass-through cables
2. Unscrew the projector cable
cover (HEX3)
5. Remove the projectors front leg
(Skip this if VMZ7ST or VMZ6ST)
1
3. Lock the angle adjustment to the
Bottom position
6. Carefully slide in the projector
and align the back legs with the
alignment holes
Advertisement
Related Manuals for ARTOME X10M
Summary of Contents for ARTOME X10M
- Page 1 Artome X10M Projector Installation 1. Lock the wheels and open the 2. Unscrew the projector cable 3. Lock the angle adjustment to the front door cover (HEX3) Bottom position 4.Open the lens latch. Remove the 5. Remove the projectors front leg 6.
- Page 2 10. Install the cable cover and 11. Connect the power and turn on Wait 2 minutes for automatic close the front door the unit configuration. The device turns off when ready. For Technical Support, please go to support@artome.fi...
Need help?
Do you have a question about the X10M and is the answer not in the manual?
Questions and answers