Administration > Management - Cisco WRT610N - Simultaneous Dual-N Band Wireless Router User Manual

Chapter 3
Priority Select the appropriate priority: High, Medium
(Recommended), Normal, or Low.
Click Apply to save your changes. Your new entry will
appear in the Summary list.
Voice Device
Voice Device
Enter a Name Enter a name for your voice device.
MAC Address Enter the MAC address of your voice
device.
Priority
Select the appropriate
(Recommended), Medium, Normal, or Low.
Click Apply to save your changes. Your new entry will
appear in the Summary list.
Summary
This lists the QoS entries you have created for your
applications and devices.
Priority
This column displays the bandwidth priority of
High, Medium, Normal, or Low.
Name This column displays the application, device, or
port name.
Information This column displays the port range or
MAC address entered for your entry. If a pre-configured
application or game was selected, there will be no valid
entry shown in this section.
Remove
Click this button to remove an entry.
Edit Click this button to make changes.
Click Save Settings to apply your changes, or click Cancel
Changes to clear your changes.
Simultaneous Dual-Band Wireless-N Gigabit Router
Administration > Management
The
administrator to manage specific Router functions for
access and security.
Router Password
Router Access
To ensure the Router's security, you will be asked for your
password when you access the Router's browser-based
utility. The default is admin.
High
priority:
Router Password
Re-enter to confirm
Local Management Access
Access via
communications protocol used to connect to servers on
the World Wide Web. HTTPS uses SSL (Secure Socket Layer)
to encrypt data transmitted for higher security. Select the
HTTP or HTTPS. The default is HTTP.
Access via Wireless
domain where you are giving wireless access to your
guests, you can disable wireless access to the Router's
web-based utility. You will only be able to access the utility
via a wired connection if you disable the setting. Keep the
default, Enabled, to allow wireless access to the utility, or
select Disabled to block wireless access to the utility.
Remote Management Access
Remote Management
Router from the Internet (outside the local network),
select Enabled. Otherwise, keep the default, Disabled.
Access via
communications protocol used to connect to servers
Advanced Configuration
Management screen allows
Administration > Management
Enter a new password for the Router.
Enter the password again to confirm.
HTTP (HyperText Transport Protocol) is the
If you are using the Router in a public
To permit remote access of the
HTTP (HyperText Transport Protocol) is the
the network's
30