Advertisement
Advertisement
Table of Contents
Related Manuals for Eisco GGSN10
Summary of Contents for Eisco GGSN10
- Page 1 GGSN10 GOGGLE SANITIZER CABINET Instruction Manual...
- Page 2 INTRODUCTION This equipment is designed to meet the demands of work places i.e. science laboratories, offices, labs, factories, hospitals etc. This unique sanitizer has been pecially designed to take care of the most delicate part of the human body i.e. the eyes. This sanitizer is used to prevent infection of the eyes spreading through goggles/ sunglasses/spectacles.
-
Page 3: Specifications
Specifications Input Voltage: 120V AC +/- 10%, 50/60Hz Input Current: 0.315A Wattage: 25 Watts (Max) Size: 26 x 10 x 29 in Weight: 54 lbs. Cord Length: 8 ft Goggle Compartments: 3.5 x 8 x 3.5 in Pollution: Installation Category: (a) Instructions for use (d) Lock (b) Viewing window... -
Page 4: Safety Precautions
SAFETY PRECAUTIONS The unit is completely protected against any hazard. Input voltage is provided through Dual Timer Switch. The unit operates only when both the doors of the machine are fully closed. The input supply is routed through the push to ON switches connected in series. Hence in the event of any door remaining open, the supply is cut-off. Further, when the timer is off both the Line and neutral inputs are completely isolated. -
Page 5: Equipment Maintenance
PRECAUTIONS Never open the doors when the timer is running. Don't view the U.V. Glass Filter continuously for a long time. Don't move the machine when it is in use. Don't put the hands inside the cabinet when the timer is still running. Make sure that proper earthing is maintained at the time of installations. -
Page 6: Fuse Replacement
IMPORTANT Protection Impairment if used in a manner not specified as per this manual. No operator serviceable parts inside. Refer to qualified personnel for servicing/ repairs only. MUST "DISCONNECT THE SUPPLY BEFORE SERVICING". FUSE REPLACEMENT By using - (minus) edge screw driver slightly turn the fuse cap anti clockwise &... - Page 7 NOTE If Equipment is not switching ON even if the fuse & everything else seems to be OK. Take out the fuse holder outside & inspect flanges visibly 9mm - 10mm Flanges should not be too close as shown in figure, in this case flanges do not make the contacts with internal body.
- Page 8 Manufactured by : U.S. Distributor : Eisco Scientific 788 Old Dutch Rd, Victor, NY 14605 Web: www.eiscolabs.com EISCO SCIENTIFIC instructions, content and design is intellectual property of EISCO...
Need help?
Do you have a question about the GGSN10 and is the answer not in the manual?
Questions and answers