Advertisement
© Copyright 2006 By Sporlan Division, Parker Hannifin, Washington, MO
NOT FOR USE WITH HAZARDOUS OR CORROSIVE FLUIDS
3-Way Valves
Installation and Servicing Instructions
ONTENTS
General Information
Replacement Parts Kits
5D, 8D, 12D & 16D 3-Way Heat Reclaim Valves
8D-SC, 12D-SC & 16D-SC 3-Way Split Condenser Valves
180 Solenoid Pilot Control
10G79B, 10G711B & 10G711C 3-Way Hot Gas Defrost Valves
Advertisement
Table of Contents
Related Manuals for Sporlan 8D7B
Summary of Contents for Sporlan 8D7B
- Page 1 5D, 8D, 12D & 16D 3-Way Heat Reclaim Valves 8D-SC, 12D-SC & 16D-SC 3-Way Split Condenser Valves 180 Solenoid Pilot Control 10G79B, 10G711B & 10G711C 3-Way Hot Gas Defrost Valves © Copyright 2006 By Sporlan Division, Parker Hannifin, Washington, MO NOT FOR USE WITH HAZARDOUS OR CORROSIVE FLUIDS...
-
Page 2: Installation Precautions
SOLDERING PRECAUTIONS CAUTION: If you are replacing the internal parts on an Solder connections on Sporlan Heat Reclaim Valves older “B” style valve with split piston rings, you must are copper. Any of the commonly used types of sol- use the existing piston and piston rings. -
Page 3: Recommended Torque
The parts kits contain gaskets for both of two different Design “AA” pilot valve designs shown at the left. Use only the gas- Tetraseal (Groove) ket that matches the design, as shown. The Tetraseal, part #641-6 is a flexible gasket and is used on design “AA”... -
Page 4: Installation
Sporlan is not sation induced shock. The use of piping brackets close to responsible for system design, any damage resulting each of the three-way valve fittings is recommended. -
Page 5: Head Pressure Control For Reclaim Systems
HEAD PRESSURE CONTROL for RECLAIM SYSTEMS When employing heat reclaim on a refrigeration sys- ity of quality hot gas at the reclaim heat exchanger. tem, the addition of head pressure controls is impor- tant not only to maintain liquid pressure at the NOTE: To calculate additional charge required for head expansion valve inlet, but also to assure the availabil- pressure control, see Bulletin 30-10, or Bulletin 90-30-1. - Page 6 Split Condenser Valves. Sporlan plate lower port recommends that recognized piping references be con- sulted for assistance in piping procedures. Sporlan is not responsible for system design, any damage resulting condenser A from system design, or for misapplication of its products.
- Page 7 A leak in many instances can be be protected from moisture and other system contami- detected by a much cooler line from the Pilot nants by the Sporlan Catch-All Filter Drier. When Control to the suction line than the liquid inlet ®...
-
Page 8: Dimensions-Inches
10-15 foot-pounds torque. 7. Reinstall the coil assembly } and connect the lead wires. * Part is available separately. Printed in the U.S. of A © Copyright 2006 By Sporlan Division, Parker Hannifin SD-114-10-406 Page 8...
Need help?
Do you have a question about the 8D7B and is the answer not in the manual?
Questions and answers