rastar 99010 Instructions

This manual is applicable to following type of products: 99010.
OPERATION GUIDE
①
②
③
When LED indicator goes
out, pairing process is
completed.
DIRECTION
ADJUSTMENT
ON-OFF SWITCH
LED indicator blinks
●The fixing piece for chassis can be used
to twist the lock of the battery cover. See
picture 1.
●Please open the lid and put 5 X
batteries into the car according to its
polarity, then close the lid and twist the
chassis piece to lock the battery cover.
See picture 1.
●Please open the lid and put the 2 X 1.5V
"AA" batteries into the controller according
to its polarity, then close the lid and twist
the chassis piece to lock the battery cover.
See picture 1.
●Every time before playing, the transmitter
needs to pair with the model car as
follows:
◆The LED indicator on the transmitter will
blink and ready for pairing. Switch on the
model car, the LED on the transmitter will
go out. This means the pairing process is
completed. Then the model car can be
fully controlled by the transmitter. See
picture 3.
●Adjust the direction adjustment switch to
control the car running in a straight line.
●Please replace battery when LED indicator
becomes dark which means low battery.
●The speed of model car will slow down
when battery is low. Please replace then.
●2.4GHz transmitters are compatible to
control several model cars at same time
without interference, provided that the
pairing process is orderly done one by one
following above steps. That is, first
transmitter finishes pairing with first model
car and keep their power on, then second
transmitter can begin to pair with second
model car...
●Please turn off the model car after playing.
1.5V "AA"