Status Bar; Options Menu Hoop Size; Density Settings; Preferences - ELNA XCHANGE Instruction Manual

Xchange Multi-Access Converter
The "Status Bar" provides information about four important items.
- "Size" – displays the size of the design
- "Pos" – displays the position of the design relative to the center of the hoop
- "St" – displays the stitch count of the design
- "Clrs" – displays the number of colors of the design
OPTIONS MENU
Hoop Size
Click Options, then Hoop Size or
shown below.
The workspace grid will increase or decrease in size to show the work area available for the
selected hoop size.
Each square of the grid equals 10 mm X 10 mm. The design you select will not be written to
a card if the design size exceeds the maximum allowable hoop size for your machine.
Density Settings (for GNC Designs Only)
Click Options, then Density Settings or
only work with GNC designs.

Preferences

Click Options, then Preferences to bring up the dialog box. Several options can be selected
depending on the brand of sewing machine you are using.
The setting for Elna/Janome/New Home software will ensure that when you save to *.SEW
format it will be compatible with Scan-n-Sew PC V1.x. The Dream Vision/ Customizer 2000
when selected will enable 78 colors for Elna/Janome/New Home in your color palette.
Click OK to apply selected preferences. Click Cancel to close the dialog box preferences
without making any changes to the software.
to select the brand of machine and hoop size as
to bring up the dialog box. Density Settings
19