Download Print this page

Razor RSF350 Instructions

Handlebar replacement

Hide thumbs Also See for RSF350:

Download this manual

Required Tools: (Not included)

• 3 mm Allen wrench

• 5 mm Allen wrench

• Small flat screwdriver

• 6 mm Allen wrench

WARNING

CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect

charger before conducting any assembly or maintenance procedures. Failure to follow these

steps in the correct order may cause irreparable damage.

Step 1

Using a 3 mm Allen wrench, loosen the set screw from

the throttle. Move the throttle away from the grip.

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.

REPLACEMENT INSTRUCTIONS

Step 2

Using a 5 mm Allen wrench, loosen the bolt on the brake

lever. Move the lever away from the grip.

RSF350 HANDLEBAR

PART # W25143060027

Need help?

Do you have a question about the RSF350 and is the answer not in the manual?

Page 1 Using a 5 mm Allen wrench, loosen the bolt on the brake the throttle. Move the throttle away from the grip. lever. Move the lever away from the grip. Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
Page 2 Step 5 Reverse the steps to install. ATTENTION: Charge battery 12 hours before using. US_250422_R Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.