Administration > Diagnostics; Administration > Factory Defaults - Linksys WRT350N - Wireless-N Gigabit Router User Manual

Chapter 3
Click Save the Log to save your log, click Refresh to
refresh the screen, or click Clear to clear the screen.
Click Save Settings to apply your changes, or click Cancel
Changes to cancel your changes.
Administration > Diagnostics
The diagnostic tests (Ping and Traceroute) allow you to
check the connections of your network components.
Administration > Diagnostics
Ping Test
Ping
The Ping test checks the status of a connection.
Enter the address of the PC whose connection you wish
to test, the packet size (default is 32 bytes) and how many
times you wish to test it. Then, click Start to Ping. The Ping
Test screen will show if the test was successful. Click Close
to return to the Diagnostics screen.
Administration > Ping Test
Traceroute Test
Traceroute
To test the performance of a connection,
click Traceroute to open the Traceroute Test screen. Enter
the address of the PC whose connection you wish to test
and click Traceroute. The Traceroute Test screen will show
if the test was successful. Click Close to return to the
Diagnostics screen.
Wireless-N Gigabit Router with Storage Link
Advanced Configuration
Administration > Traceroute Test
Administration > Factory Defaults
The Administration > Factory Defaults screen allows you
to restore the Router's configuration to its factory default
settings.
NOTE: Do not restore the factory defaults unless
you are having difficulties with the Router and
have exhausted all other troubleshooting
measures. Once the Router is reset, you will have
to re-enter all of your configuration settings.
Factory Defaults
Restore Factory Defaults
to the default values, select Restore Factory Defaults.
Any settings you have saved will be lost when the default
settings are restored.
Administration > Factory Defaults
To reset the Router's settings
24