Eu Regulatory Information; Deployment Statement - Cisco AIR-AP1010 - 1000 Series Lightweight Access Point Quick Start Manual

External Antennas
The AIR-AP1020-A-K9, AIR-AP1020-E-K9, AIR-AP1020-J-K9, AIR-AP1030-A-K9,
AIR-AP1030-E-K9, and AIR-AP1030-J-K9 Cisco Aironet 1000 Series IEEE 802.11a/b/g lightweight
access points can be used with external antennas with the following characteristics:
•
•

Deployment Statement

This product is certified for indoor deployment only. Do not install or use this product outdoors.

EU Regulatory Information

Compliance Information for Cisco Aironet 1000 Series IEEE 802.11a/b/g lightweight access points:
1.
2.
3.
Note •
•
Generally, the 5150-5350 MHz, 5470-5750 MHz, and 2400-2483.5 MHz bands are allowed in most EU
countries. However, there are several country specific restrictions that apply to different bands on a
country-by-country basis.
The following entries specify countries with specific restrictions:
These restrictions may evolve. It is recommended that you check with their local authorities for latest
Note
requirements
•
•
AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal Antennas - Quick Start Guide
A-4
5 GHz patch antenna: 6 dBi net gain.
2.4 GHz patch antenna: 6 dBi net gain.
Standards met:
Radio: EN 301 328, EN 301 893
–
EMC: EN 301489-1, EN 301 489-17
–
– Safety: EN 60950
– RF Safety: EN 50371
CE Marking: Cisco Aironet 1000 Series 802.11a/b/g lightweight access points are identified with
this CE marker:
EU Country Restriction:
The Cisco Aironet 1000 Series IEEE 802.11a/b/g lightweight access point is intended for indoor use
only.
The Cisco Aironet 1000 Series IEEE 802.11a/b/g lightweight access point meets EU DFS
requirement.
Austria - Only transmission within the frequency band 5150-5250 MHz is allowed. The band
5470-5750 MHz is not allowed.
Belgium - The frequency band 5470-5750 MHz is not allowed.
Appendix A Planning Notes
78-17146-01