Table of Contents
Advertisement
Mounting the Access Points
Figure 9
2.
Copy the MAC address(es) from the label(s) on the AP onto the corresponding location on the map.
MAC addresses have the format 00xxxxxxxxxx.
3. You have already attached the flush-mount bracket to the wall in "
4.
Slide the screws into the keyhole slots on the mounting bracket as shown in the following figure.
Be sure the side of the AP with the door is facing away from the wall (flat Side A toward the inside of
Note
the building). This ensures that the correct antenna is facing the building, and makes future upgrades
easier.
Note
If the screws do not securely hold the bracket, remove the AP and adjust the screws until they securely
hold the bracket.
Figure 10
Attach the cables to the sides of the AP.
5.
AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal
12
Attaching the Mounting Screws and Spring Washers to the AP
A. Screws and spring washers
Attaching the AP to the Flush-Mount Bracket
Installation and Configuration
B. Completed assembly
Preparing Mounting
Locations"
.
7817146-01
Advertisement
Table of Contents
