Figure 6-15: Wireless - Advanced Wireless - Linksys WAP54GPE - Wireless-G Exterior Access Point User Manual

Wireless-G Exterior Access Point
Wireless Repeater
When set to Wireless Repeater mode, the Access Point receives the signal from the remote Access Point and
retransmits its signal. (This feature only works with the Linksys Wireless-G Exterior Access Point (model
number: WAP54GPE), Wireless-G Interior Access Point (model number: WAP54GP), Wireless-G Access
Point (model number: WAP54G), and Wireless-G Broadband Router (model number: WRT54G).
To configure a Wireless Repeater environment, click Wireless Repeater and enter the MAC addresses of the
remote access points in the MAC fields. If you do not know an access point's MAC address, click the Site
Survey button. Select the access points you want to use and click the Apply button. Then click the Close
button to return to the AP Mode screen. If you do not see the access point you want, click the Refresh button
to run another site survey.

Figure 6-15: Wireless - Advanced Wireless

Chapter 6: Configuring the Wireless-G Exterior Access Point
30
The AP Mode Tab