Ava Modulating Multi Turn S20 Support Document

SMART ACTUATORS WITH OLED SCREEN, TOUCH BUTTONS AND SMARTMENU ™
All of our Smart actuators have a colour OLED screen and 3 x touch buttons. The screen will typically tell you all you need t o know about your
actuator, from the input command to the actual position, any problems with the actuator such as loss of power
flash ALERT if the actuator as an alarm condition such as an over torque situation or valve jam. As standard, all of our actu ators have Local
Control as explained below. The touch buttons are used to navigate our onboard firmware to adapt and change the actuator settings to ena-
ble you, the user to customise our Smart actuators to your application and own specific
How to access the main customer accessible menus:
Main Menu: Hold M for 3 seconds and enter the password 333 to access main user Main Menu.
Local Control: Hold K3 (bottom button) for 3 seconds and enter the password 111 to access Local Control / manual override
Reset: Need to go back to factory reset/default settings? Hold all 3 buttons for 3 seconds and enter 6666.
Note: If the actuators is left in a menu screen without a change in 120 seconds, the actuator will exit the menu.
1
2
Understanding the default screen:
1. Input Command: ON = Open OFF = Closed
2. Angle: Shown as %. 0% is Closed 100% Open
3. IDLE: Actuator is waiting next command
4. M = Button to enter / use in Smart Menu
New feature, we are adding a QR label to all of our products that will enable users of our product to have quicker
and more direct access to support documents via our new purpose built QR website. Simply scan the QR code
using your Smart phone camera and you will be taken directly to the specific actuator you have on site and will
have access to Technical Datasheets, Firmware guides and product support videos.
Technical Support: +44(0)1386 556847 Technical Support: +44(0)1386 556847
SERIES 20-110 MT MODULATING
USER GUIDE VERSION 14.0
•
Screen by screen user guide
•
Covers Smart Series Multi Turn Modulating
•
For Series 20, 50, 80 and 110Nm actuators
•
Our products are continually developed through Firmware revisions.
•
We will release an update to show changes between software as and when we re-
lease new firmware versions.
•
Check our Product Library online at www.avactuators.co.uk/support
4
3
5
6
this is the screen you will see when not in a menu but the actuator is powered
5. K2 = Button used in Smart Menu
6. K3 = Button used Smart Menu/Local Control
7. On power up, shows Firmware Version Number
8. On power up, shows total number of cycles
FIRMWARE SUPPORT DOCUMENT
Version 001: 13/10/22 subject to change without notice
requirements.
7
technical@avactuators.co.uk technical@avactuators.co.uk
(if failsafe) or
8 9
On power up shows the
9.
total number of errors.
You can also view this
screen whenever
exiting a menu. *Note
that this information
turns off quickly.
English version. Available in Spanish