Delta Electronics Network Device DN02 Instruction Sheet

DeviceNet Communication Module Instruction Sheet
1. Panel Appearance: 1) For RS-485 connection to VFD series 2) Communication port for connecting
2. Network Wiring: Picture right hand side below shows rough wire configuration. Refer to DeviceNet
3. Mounting Method: Picture right hand side below shows how to mount this communication module
42.0 [1.65]
Network
Module
SP
ADD1
ADD2
Data Rate
4. Power Supply: No external power needed. Power is supplied via RS-485 that is connected to VFD

5. LEDs Display:

SP: Green LED means in normal communication, Red LED means abnormal.
Module: Green blink LED means no I/O data transmission, Green steady LED means I/O data
transmission OK.
Red LED blinking or Red LED mean module communication is abnormal.
Network: Green LED means DeviceNet in normal communication, Red LED means abnormal
★ Refer to user manual for detail information-- Chapter 5 Troubleshooting.
DeviceNet network 3) Address selector 4) Baud rate selector 5) Three LED status
indicators for monitor. (Refer to the figure below)
wiring spec for physical wire connection.
onto DIN Rail
34.0 [1.34]
series. Six pins RJ-11, which is packed together with this communication module, is
used to connect the RS-485 between VFD series and this communication module for
power. This communication module will perform the function once is connected. Refer
to following paragraph for LED indications.