Download Print this page

Rubbermaid WaveBrake Manual

Also See for WaveBrake:

Table of Contents

Parts Included

Place the WaveBrake® bucket in an upside down position as shown in Figure 1.
Then, place the handle between the two ribs of the bucket as shown in Figure 2.
Let go of the handle as shown in Figure 3.
To avoid damaging the bucket and handle, use a rubber mallet and lightly strike the red handle surface as shown in Figure 4 while holding the red handle.
Using a mallet ensures the handle snaps into place in the slots as shown in Figure 5. This installation is one time only; once installed, it cannot be removed.
Ready to use as shown in Figure 6.