Pioneer PRV-LX1 Command Protocol Manual page 11

7X 20 Status Data
Return all or part of the following data that corresponds to the "61:20 Status Sense" command
Data MSB
# Bit – 7
0
1 Standby
Servo
2
Lock
3
4
UNTREAD: bit set when the selected drive is open
LOCAL: bit set when [Operation/Control Setting/Control] is set to Local
(remote command is not available unless set to Remote)
STANDBY: bit set in StandbyON mode - also set under Rec and Play
STOP: bit set in Stop mode
EJECT: bit set when the selected drive is unloading
REW: bit set in Full Rewind mode
FF: bit set in Full Forward mode
REC: bit set when recording - with TimeShift Play mode turned on while recording, this bit is
cleared
PLAY: bit set in Rec or Play
SERVO LOCK: bit set in Rec or Play
SHUTTLE: bit set in Shuttle mode
JOG: bit set in Jog mode
VAR: bit set in Var mode
TAPE DIR: bit set in Reverse Play
STILL: bit set in Record–Pause or Play–Pause
CUE UP: when the PRV-LX receives a "20:30 Preroll" or "24:31 Cue Up With Data" command,
this bit is set after searching is complete and the unit switches to Pause
(bit is cleared when playing point moves beyond the search point)
PREROLL: bit set when a "20:30 Preroll" or "24:31 Cue Up With Data" command is received
(kept till searching is completed)
E3 51 11 Title Search (PRV-LX1 original command)
The command searches to a recorded title number
Values are 1-255 (0x01 0x00 – 0x55 0x02)
DATA – 2
10 1
Titles Title
MSD LSD
Execute title search to the title number given by DATA-2 and DATA-3. When Time Shift PLAY is
enabled when recording, if the search title number is same as the title number being recorded,
Time Shift PLAY executes. However, if the search title number is smaller than Title number being
recorded, another title plays while recording.
Bit – 6 Bit – 5
UnThread
Stop
Shuttle
DATA – 3
always 100
0 Titles
MSD LSD
Page 10 of 18
Bit – 4 Bit – 3 Bit – 2
Eject REW
Tape
Jog VAR
PRV-LX1 RS-422A Protocol
LSB
Bit – 1
Bit – 0
Local
FF Rec Play
Still Cue Up
Dir
Preroll