INSTALLATION 1.0 LOCATION The cabinet must not be tilted. If necessary, some models may be tilted to the side indicated on the packaging. If not, it cannot be tilted. You must wait for at least 2 minutes from standing the cabinet up before starting it up.
Do not install the cabinet outdoors. A cabinet consumption table for adjusting the protection is attached PORT. DIS. MOD. A[max] W[watt] GENERAL DIF. HE706/P 230v 50Hz 30 mA HD706/P 230v 50Hz 30 mA HD1412/P 230v 50Hz 30 mA HE1412/P 230v 50Hz 30 mA...
GRAMS OF COOLANT GAS CLIMATIC CLASS (N=4) ó (T=5) STANDARD GENERAL MEASUREMENTS ON THE OUTSIDE OF ALL THE CABINETS AND EMERGENCY DRAINAGE ANNOTATION IN MM MODEL DIMENSIONS SNACK LENGTH DEPTH HEIGHT HD706/P, HE706/P 2067 HD1412/P, HE1412/P 1388 2067 EMERGENCY DRAINAGE INSTALMENT MEASUREMENTS...
1.4 START-UP Once the inside of the cabinet is clean, plug it into the electricity network and turn the switch to On or I. The thermostat temperature indicates the cabinet inner temperature. Three minutes after turning the switch on, the compressor operating led must be permanently on.
WARNING Do not damage the refrigeration circuit. WARNING: Do not use electrical appliances inside the compartments designed for storing food unless they are of the type recommended by the manufacturer The cabinet you have purchased is designed to preserve drinks and food. We recommend not putting hot food or containers, chemical, corrosive products or medicines inside the refrigerator, and avoiding the incorrect use of the unit.
2.3 Limits The climatic class 4 operating limits established for the cabinet are: Setting Limits Room temperature + 38 ºC + 54 qC Condensation temperature Relative humidity MAINTENANCE With these guidelines, we would like to offer both you and the technical assistance service help so that the cabinet always works perfectly throughout its useful life.
Check that the condenser is clean: You must bear in mind that the cleaner the refrigerator is the greater the energy saving, particularly the condenser’s ribbing. The frequency of this cleaning will be determined by the characteristics of the premises. If it is dirty, call the technical support service to clean it.
Need help?
Do you have a question about the HD706/P and is the answer not in the manual?
Questions and answers