Mounting - Panasonic AV-HS04M3 Operating Instructions Manual

Mounting

Install this board in the multi-format live switcher AV-HS400N/E.
<Notes>
 Be sure to ask the store or dealer where you purchased the product for assistance
with mounting and removal.
 Set to OFF and unplug the power connector before mounting and removal.
 Before handling this board, touch a metal part of the AV-HS400N/E to discharge the
static electricity from the human body.
An anti-static wrist strap is recommended for safety. Failures may be caused if you
touch this board while you are still charged with static electricity.
 Keep the metal parts of this board free of contact with other metal parts.
 Be sure to mount the blank panel installed with the AV-HS400N/E, after removing this
board.
 When installing or removing this board, take care not to hurt yourself on the edges
and metal parts of the boards.
 Turn off the power of the AV-HS400N/E, and unplug the power cord.
 Loosen the two screws of SLOT1 or SLOT2 on the input side at the rear of the AV-
HS400N/E, and remove the blank panel.
Blank panel
Screw
8 (E)
SLOT2
SLOT1
Screw