Table of Contents
Advertisement
Quick Links
EU70, EU75, EU95, and EV00 Baths
INSTALLATION AND OPERATION INSTRUCTIONS
Complete and mail in the product registration card provided with your unit.
Write and save the model and serial number of your unit below.
Date purchased _______________________________________________________
Purchased from _______________________________________________________
Installed by ___________________________________________________________
Serial Number _________________________________________________________
Model _______________________________________________________________
Installer: Leave this manual for homeowner.
Homeowner: Read this manual and keep for future reference.
Copyright © 2007 by Jacuzzi Whirlpool Bath
Era™ Freestanding Baths
Save these Instructions for Future Use
Owner's Record
GB17000A • 9/07
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Jacuzzi Era EU70
Summary of Contents for Jacuzzi Era EU70
- Page 1 Owner’s Record Date purchased _______________________________________________________ Purchased from _______________________________________________________ Installed by ___________________________________________________________ Serial Number _________________________________________________________ Model _______________________________________________________________ Installer: Leave this manual for homeowner. Homeowner: Read this manual and keep for future reference. Copyright © 2007 by Jacuzzi Whirlpool Bath GB17000A • 9/07...
-
Page 2: Safety Instructions
CAUTION: Jacuzzi Whirlpool Bath recommends having a certified plumbing technician install your bath. CAUTION: To ensure that no damage has occurred to your bath during shipping, it is important to check your bath for damage prior to installation in your home. -
Page 3: Table Of Contents
USE INSTALLATION INSTRUCTIONS SUPPLIED WITH PRODUCT. Jacuzzi Whirlpool Bath has obtained applicable code listings (standards) generally available on a national basis for products of this type. It is the responsibility of the installer/owner to determine specific local code compliance prior to installation of the product. -
Page 4: General Information
Please read this manual carefully before installation and Ended Bath with Wood Frame (Model EU95 and EV00; and install the bath accordingly. Jacuzzi is not responsible for any Double-Ended Bath with Pedestal (Model EU95 and EV00), damage due to improper installation or an installation that is CAUTION: Do not place light bulbs or other high temperature not in accordance with your local building and plumbing codes. - Page 5 P41161W Rubber 4 pc xΦ12.5 EV12 71x42 gasket Anchor, Φ25 P5162N swell screw 4 pc M8x75 P41160N Flat washer 4 pc xΦ12.5 M12x30 P5181N-1 screw, hex 4 pc head Jacuzzi Whirlpool Bath: Installation and Operation Page GB17000A • 9/07...
-
Page 6: Installation
The Preassembly and Initial Leak Test gives the the bath upside down on a protective covering and assembly recommended order of steps for receiving the Jacuzzi bath the four feet as shown in Figure 2. Any of the feet can be used and preparing it for installation in its permanent location. -
Page 7: Attach Wood Frame To Bath
Overflow and Drain Assembly instructions. Post All thread Flat washer Bath (Up-side down) Figure 4. Attach Pedestal Legs Rubber gasket Flat washer screw, hex head Figure 3. Assembly of Wood Frame Jacuzzi Whirlpool Bath: Installation and Operation Page 7 GB17000A • 9/07... -
Page 8: Install Overflow And Drain Assembly
Wall 5.75“ Cold Figure 6. Installation of Drain water water Φ1.00 8.00 in from wall, min. Rim of tub 8.00“ Φ1.50 Drain Figure 8. Drain and Supply Line Locations Jacuzzi Whirlpool Bath: Installation and Operation Page GB17000A • 9/07... -
Page 9: Install Slipper Bath
5. Drill a 7/16 in hole the depth of the 1-1/2 in screw length for each anchor (12c). Then remove the paper from the floor and discard. Claw Claw foot foot Anchor Paper Figure 12. Secure EU-95 and EV-00 Baths to Foundation Jacuzzi Whirlpool Bath: Installation and Operation Page 9 GB17000A • 9/07... -
Page 10: Install Bath With Wood Frame
6. Remove the bath and place it on the pedestal or on a protective covering for drilling the holes for the anchors. 7. Drill a hole the depth of the screw length for each anchor, see Figure 16. Jacuzzi Whirlpool Bath: Installation and Operation Page 10 GB17000A • 9/07... -
Page 11: Final Leak Test
1. Polish the surface of the scratch with a metal or car polish to work up the bright surface. 2. Use a 1000 grit sand paper to polish the surface of the scratch. If necessary, repeat step 1 above. Jacuzzi Whirlpool Bath: Installation and Operation Page 11... -
Page 12: Authorized Service
USE INSTALLATION INSTRUCTIONS SUPPLIED WITH PRODUCT Jacuzzi Whirlpool Bath has obtained applicable code (standards) listings generally available on a national basis for products of this type. It is the responsibility of the installer/owner to determine specific local code compliance prior to installation of the product. - Page 13 WARRANTY COVERAGE Jacuzzi Whirlpool Bath© (the Company) offers the following express limited warranty to the original purchaser of any ERA Freestanding bath (“unit”) who purchases the product for personal or single family use (“user”). The Company will repair or replace, at its option, the unit or its equipment in accordance with the following terms and conditions.
- Page 14 If order to obtain warranty service, call the warranty service number below for the location of the nearest Authorized service Agent or write: Jacuzzi Whirlpool Bath© Warranty Service Department...
Need help?
Do you have a question about the Era EU70 and is the answer not in the manual?
Questions and answers